This fully assembled 12V PIR Motion Detector module is just 27mm square and uses the latest SMT. It is similar to the 3076R PIR detector module that we sell but with the following differences:
| Characteristic | 3133 | 3076R |
|---|---|---|
| Supply Voltage | 10-14Vdc | 4-12Vdc |
| Output | active LOW, open collector | active HIGH, open collector |
| Dimensions | 27 x 27 x 23 mm inc header pins | 25 x 35 x 18 mm plus lead |
| Board connection | 3-pin header | 75mm flying lead |
| Output works with | Relay Boards: 8043-12 or 3044 or 3156 Timer Boards: 3141 | Relay Boards: CT0004 or 3044 or 3156 or 1168 Timer Boards: 3141 |
The output can be used with loads of up to 100mA. If the PIR and your load share the same power supply, connect your load (marked RL in the Datasheet below) between +12V (Pin1/VCC) and the OUT (Pin3). See our open collector faq sheet for more info.
Supplied fully assembled with Fresnel lens and ready to use (picture above shows two units - one with lens removed).
Specifications| Input Voltage | 10-14V dc |
| Operation current at 10-14V | 600uA |
| Standby current | 400uA |
| Output load | 100mA Maximum |
| Output voltage | 0.2V |
| Output duration | 0.5 seconds minimum |
| Lens Angle (degrees) | 100H x 60V |
| Lens diameter | 24mm (dome height 12mm) |
| Module dimensions | 27 x 27 x 23 mm inc. header pins |
| Product Format | PRE-ASSEMBLED Electronic Module Format Product Formats Info |
| Documentation | Datasheet |
