The Cebek LS-4 module provides a simple but effective 4-Channel light chaser board for LED strips. The LS-4 uses P16NF06 MOSFET transistors to step in sequence between the four 12Vdc, 2Amp rated outputs. Step interval time is adjustable between 0.4 and 12 seconds.
An onboard DIP switch allows selection of 4, 3 or 2 active channels.
Each channel has an onboard LED to indicate when it is active. All inputs and outputs have reverse polarity protection.
* The minimum step interval is approximately 0.4 Seconds (not 0.2 Seconds stated in the user manual). To increase the flash rate, the step interval can be reduced to 0.2 Sec. by changing capacitor C4 from 100uF to 47uF (or 22uF for 0.1 Sec.).
This module is designed for use with 12V LED strips (up to 4 metres per output), LED bulbs and incandescent filament bulbs only. It is NOT suitable for use with inductive loads like transformers, motors, etc.
Specifications| Operating Voltage | 12Vdc |
| Current Consumption | 10mA (control circuit only) |
| Output Load (per channel) | 2 Amps Max. (24 Watts) |
| Output Voltage | 12Vdc |
| Step Interval | Minimum: 0.4 Seconds (* see note above) Maximum: 12 Seconds (approx.) |
| Board Connections | Screw terminal blocks |
| Dimensions (WxDxH) | ~ 72 x 87 x 20mm |
| DIN-RAIL Mounting | C7566 |
| Enclosure | WCAH2851 |
| Weight | 44g |
| Product Format | PRE-ASSEMBLED Electronic Module Product Format Info |
