Stereo power amplifier based around two TDA2030 ICs. It has good input sensitivity, low distortion, good operating stability and full protection against overloads and output short-circuits.
It can be used as a booster amplifier for existing small systems or to drive a second pair of speakers besides the ones already connected to the system.
The board needs a symmetrical power supply of +/- 18Vdc, 3A and can be connected to loads of 8 or 4 Ohm. Large heatsink supplied. Kit version includes solder for assembly.Specifications
|Supply voltage||+/- 18Vdc, 3A symmetrical (see text)|
|Current consumption||3A maximum|
|Input impedance||500K Ohms|
|Input sensitivity||250 mV|
|Signal to noise ratio||80 dB|
|Frequency response||20 - 20,000 Hz +/- 1 dB|
|Distortion||0.5 % maximum|
|Load impedance||4 - 8 ohm|
|Board Connections||Solder Posts|
|Product Formats||SELF-ASSEMBLY Electronic Kit (KT) or|
PRE-ASSEMBLED Electronic Module (AS) Product Formats Info
TDA2030 IC Data Sheet
Amplifier Power Supply General Advice
Mono Hi-Fi amplifier kit based on the TDA2030 with very good specifications despite its apparent simplicity. It can be used together with kits 1070 and 3100 to make a modern STEREO amplifier of very high quality...
This is a DC power supply board designed for our 3106 audio power amplifier. It is also suitable for any power amplifier module or circuit requiring a positive and negative rail voltage of up to 45 Volts per side...
15W RMS stereo audio power amplifier module. Simply 12-35Vdc power supply. Output impedance of 4-8 Ohms. Supplied fully assembled and tested with instructions...