New Improved Version
Treat your classic car to some modern technology with this useful variable intermittent windscreen wiper controller. Onboard potentiometer adjusts delay time between wiper sweeps from 3 to 40 seconds approx. Helps to reduce wiper chatter, improve safety and prolong the life of wiper blades and windscreen.
The operation is similar to that seen on most modern vehicles - Wipe > Park > Pause > Repeat. Wipers perform a single sweep, park then pause for the user-set delay period. The cycle automatically repeats until the wipers are turned off. The board does not offer a continuous sweep setting, only intermittent operation as described above.
Easily fitted to most 12V negative earth vehicles with self-parking wiper motors. Can be fitted to either front or rear screen wipers.
Just 4 connections are required:
Now available in two version:
Please note that we are unable to provide vehicle specific installation advice - refer to the user manual below and your vehicle wiring diagram or have an auto electrician install it for you.Features
|12-15Vdc from vehicle battery (negative earth)
|Quiescent: < 10 mA
Active: < 40 mA
|2 to 20 operations per minute approx.
|5 Amp max. (as supplied)
|40 x 60 x 20mm
(or WCAH2855 but not much space for wires)
|Safety Fuse (recommended)
|Screw terminal blocks
|SELF-ASSEMBLY Electronic Kit (KT) or
PRE-ASSEMBLED Electronic Module (AS) Product Formats Info
|8093 User Manual
8093SW User Manual