The Cebek TL-601 is a highly flexible 2-Channel 12/24Vdc powered Momentary, Toggling/Latching or Delay Timer RF relay receiver module supplied pre-built into an IP55 rated enclosure complete with external rod antenna.
Each relay output on this receiver board can be set individually to operate in the following modes:
Reset Inputs: each channel has a reset input to immediately turn off (or disable) the corresponding relay output (all operating modes). Connect to volt-free contact closure like a switch, manual over-ride button, etc. All channels are disabled if any of the reset inputs remain closed.
From our Group 3 range of 433.92MHz RF remote control modules - mix and match from a variety of receiver and transmitter options to suit your needs (see compatibility table below). Up to 5 Group 3 transmitters can be learnt by a receiver. Other unlearnt transmitters within range will be ignored.
SpecificationsOperating Voltage | 12 or 24Vdc |
Current Consumption | 130mA max |
Suitable Power Supply | CFE103 |
Output | 2 x SPDT Relay |
Maximum Output Load (Resistive) | Up to 240Vac or 28Vdc @ 3 Amps max. (Relay Datasheet) |
Relay Connections | NO, NC, C (Relay FAQ) |
Output Channels | 2 |
Relay Action | Momentary, Latching, Timer |
RF Frequency | 433.92 MHz |
Compatibility | RF Group 3 |
Antenna | Included |
Board Connections | Screw terminal blocks |
Dimensions | 98.75 x 72 x 30 mm |
Weight | 420g |
Enclosure Rating | IP55 |
Approvals | EMC 89/336/EEC and 93/68/EEC and amendments 23/31/CEE with ETS legislation 300-200 |
Product Format | PRE-ASSEMBLED Electronic Module Product Format Info |
TL-300 | 1-Channel Remote Control Transmitter, 25m |
TL-301 | 2-Channel Remote Control Transmitter, 25m |
TL-321 | 1-Channel Remote Control Transmitter, 100m |
TL-322 | 2-Channel Remote Control Transmitter, 100m |
TL-323 | 1-Channel Remote Control Transmitter, 300m |
TL-324 | 2-Channel Remote Control Transmitter, 300m |
TL-325 | 2-Channel Remote Control Transmitter Module, 100m |
TL-326 | 2-Channel Remote Control Transmitter Module, 300m |
NB Only one channel will operate if you use a 1-channel transmitter with a 2-channel receiver. You can use a 2-channel transmitter with two 1-channel receivers (see User Manual for details). You cannot use multiple button presses or simultaneously use two transmitters if they are operating in range of one another (regardless of their coding). |