This external signal (0-10Vdc) or potentiometer operated AC motor speed controller uses Phase Angle Regulation (PAR) and a triac output and allows you to adjust the speed of 230Vac 50Hz single-phase "universal" motors as used in power drills, vacuum cleaners, etc and an operating load of up to 5000 Watts.
Motor speed adjustment range is from 0 to 100%. You can use either an external 10K potentiometer (not included) or a 0-10V dc control signal. The dc control signal input is electrically isolated from the mains. The board can be modified to accept an input signal range of 0 - 5Vdc by soldering a wire link across resistor R6.
Signal input operation can be set so the output is either directly or inversely proportional to the control signal.
Please see User Manual for full description.
PRODUCT SELECTION NOTES: Suitable for controlling most 230Vac 50Hz single-phase "universal" motors, light regulators, 230V signals through automation, etc. NOT suitable for use with synchronous AC motors, capacitor-start/run AC motors or inductive loads like halogen or PL lamps, neon, etc.. Ask the manufacturer to confirm if their motor is suitable for control using a Phase Angle Regulation (PAR) style controller BEFORE you buy this product! The motor controller should have an output load capacity at least 25% above the motors peak power requirement. Please do NOT rely on motor rating plates for power consumption figures as they often quote average not peak power. You should verify the actual peak power at start-up and under full load before selecting an appropriate size motor controller.
Suitable for use with DIN-RAIL Mounting (Order Code C7589).
Please see CR026 for a 5000W version of this product.
FeaturesOperating Voltage | 230Vac 50Hz mains (the interference filter mentioned in the User Manual is optional and is not necessary in most installations) |
Output Load | 5000 Watts maximum |
Control signal voltage | 0 - 10V dc (board can be easily modified to accept 0 - 5V dc) |
External potentiometer | 10K Ohm (Order Code RE.POT.10KLIN-PLASTIC) |
Output Load (Minimum) | 50 Watts |
Operating Voltage (Minimum) | 90Vac |
Board Dimensions (WxDxH) | ~ 121 x 107 x 55 mm |
DIN-RAIL Mounting | C7589 |
Product Format | PRE-ASSEMBLED Electronic Module Product Format Info |
WARNING | Product operates at mains voltage and is not suitable for children. An isolating enclosure is required (not included). Installation, testing and commissioning should be performed by a competent person. Mains Electricity Info |