This external signal (0-10Vdc) or potentiometer operated DC motor speed controller uses a PWM triac output and allows you to adjust the speed of single-phase, universal DC motors with 8 - 30V dc supply and an operating load of up to 8 Amps.
Motor speed adjustment is from 0 to 100% is achieved using either an external 0-10V dc control signal or a 10K potentiometer (not included).
Signal input operation can be set so the output is either directly or inversely proportional to the control signal.
Please see User Manual for full description.
PRODUCT SELECTION NOTES: This module can be used to control DC resistive loads like lights, machinery pedals, universal motors, control automation, modelling, etc… . It is NOT suitable for use with inductive loads like neon's, halogen lamps, transformers, etc,.. The motor controller should have an output load capacity at least 25% above the motors peak power requirement. Please do NOT rely on motor rating plates for power consumption figures as they often quote average not peak power. You should verify the actual peak power at start-up and under full load before selecting an appropriate size motor controller.
Please see CR035 for an 25A version of this product.
SpecificationsOperating Voltage | 8V - 30V dc (e.g. Order Code CFE017 & CFE018) |
Output Load | 8.0A maximum |
Module Power Consumption | 35 - 130mA |
Control signal voltage | 0 - 10V dc |
External potentiometer | 10K Ohm (Order Code RE.POT.10KLIN-PLASTIC) |
Polarity Protection | Yes |
Board Dimensions (WxDxH) | ~ 72 x 87.5 x 45 mm |
Enclosure | WCAH2852 |
DIN-RAIL Mounting | C7566 |
Product Format | PRE-ASSEMBLED Electronic Module Product Format Info |