The Cebek PM-2 is a microphone preamp module with 560 Ohm LOW input impedance. It is designed for use with low and high impendence microphones.
The Cebek PM-2 is from our selection of mono audio preamp modules that run from a 6-18V dc power supply and have an onboard potentiometer for gain adjustment. Other modules in the range are:
These modules can be used with Cebek PM-5 - Mono Pre-Amplifier Module with Tone Controls.
All modules are supplied fully assembled and tested with instructions so you only need to make the necessary connections.Specifications
|Supply Voltage||6-18V dc (e.g. CFE103 or CFE002)|
|Current Consumption||2mA min. - 10mA max.|
|Input Impedance||560 Ohms|
|Signal Input||5mV min. - 300mV max.|
|Output Signal||2V max.|
|Output Impedance||1K Ohm|
|S/N Ratio||80 dB|
|Frequency Response||30Hz - 17KHz|
|Dims. (WxDxH)||50 x 35 x 20 mm|
Multipurpose black ABS plastic enclosure approx. 83 x 54 x 30mm that can be used to house a number of suitable size kits and modules...
Nominal 12Vdc, 130 mA stabilised power supply module complete with an onboard 230Vac mains transformer. The module provides a stabilised, adjustable (10-15V) output with short circuit protection, onboard fuse, LED 'On' indicator and screw terminal blocks ...
A 47K Ohm high impedance mono microphone audio preamp module that runs from a 6-18V dc power supply (for example our CFE002) and has an onboard potentiometer for gain adjustment...
General purpose 10K Ohm impedance mono audio preamp module that runs from a 6-18V dc power supply (for example our CFE002) and has an onboard potentiometer for gain adjustment...
A 22K Ohm impedance guitar preamp mono audio preamp module that runs from a 6-18V dc power supply and has an onboard potentiometer for gain adjustment...