High power, hi-fi quality class AB audio amplifier module using a TDA7294 IC. This amazing little IC was designed for use in high quality hi-fi applications and has very low noise and distortion, wide bandwidth and good output current capability.
It provides an impressive 50W RMS into 8 Ohm or 82W RMS into 4 Ohm with only 0.1% THD.
Mute and Standby are brought out to connection pads on PCB. IC has internal short circuit and thermal protection, so is quite robust.
Space is provided on the PCB for mounting a 1.4° heatsink (not provided).
All components including IC insulation bush, screws, nuts & washers and TO-3 silicon-impregnated insulating washer are provided. Heat sink, speaker, cables and +/- 30V power supply not provided.Specifications
|Input Voltage||+/- 24 - 36V (see documentation for details)|
|Power Supply||3186 (with a suitable mains transformer)|
or CFS050 (includes transformer)
|Input Sensitivity||1.3V (50W into 8 Ohm)|
|Input Impedance||10K Ohm|
|Freq. Response||16Hz - 100KHz|
|Output Impedance||4 - 8 Ohm|
|Output Power||50W into 8 Ohm (0.1%THD)|
82W into 4 Ohm (0.1% THD)
|S/N Ratio||105dBa (1W/8 Ohm)|
|THD (40W into 8 Ohm)||0.002% (1kHz)|
0.04% (20Hz - 20kHz)
|Board Dimensions||84x83mm (heatsink area of PCB is 37x83mm but can overhang if required)|
|Board connections||Solder pads|
|Product Formats||SELF-ASSEMBLY Electronic Kit (KT) or|
PRE-ASSEMBLED Electronic Module (AS) Product Formats Info
TDA7294 IC Data Sheet
Amplifier Power Supply General Advice
Discrete mono audio power amplifier electronic kit with 100W RMS output (4 Ohm). Epitaxial Darlington transistors. Low distortion. Excellent value for money. Gives great results...
Based on a tried, tested and reliable design using 2N3055 transistors. Relay soft start delay circuitry and current limiting for loudspeaker protection. Easy bias adjustment with the help of two LEDs...
This medium output power audio amplifier is specially designed for audiophile applications. It provides 75W RMS @ 4 Ohm (50W RMS @ 8 Ohm) and features a special noiseless PCB design with separate audio and power earthing rails...
Circuit uses a high fidelity LM1875 amplifier IC and delivers up to 25W RMS into 8 Ohms @ 1% THD. S/N ratio: 100dB...
This is a DC power supply board designed for our 3106 audio power amplifier. It is also suitable for any power amplifier module or circuit requiring a positive and negative rail voltage of up to 45 Volts per side...
Dual polarity +/- 32Vdc, 3 Amp stabilised power supply module complete with a 230Vac mains transformer. A secondary output provides an adjustable 18Vdc, 150mA. The module provides a stabilised output with short circuit protection, LED 'On' indicator, onboa...